Télécharger Imprimer la page

Bosch PRS926B90E Mode D'emploi page 8

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 32
Switching on
automatically
Safety system
Termopar
Switching off a burner
Power levels
Setting
Control off
Maximum capacity or
Large flame
aperture and electricity
on
Economy
Minimum capacity or
flame
aperture
If your hob features the automatic ON function
(ignition sparkers):
1. Press the chosen burner control and turn it
anticlockwise to the maximum power setting.
While the control is still pressed down, sparks are
produced on all burners. The flame ignites (it is no
longer necessary to press down the control).
2. Turn the control to the required setting.
If it does not come on, turn the control to the off
setting and repeat the steps above. This time,
press and hold the control for longer (up to 10
seconds).
Warning! If after 15 seconds have elapsed, the
flame does not ignite, switch off the burner and
open a nearby window or door. Wait at least one
minute before trying to switch the burner back on.
Depending on the model, your hob may have a
safety system (termopar) that prevents the flow of
gas if the burners accidentally switch off. To ensure
that this device is active, switch on the burner as
usual and, without releasing the control, press and
hold it down firmly for 4 seconds after lighting the
flame.
Ignition sparker
Turn the corresponding control clockwise to the 0
setting.
The progressive controls can be used to control
the power needed, from minimum to maximum
power.
7

Publicité

loading