Worx WX80RS Notice Originale page 9

Saw with moderate pressure
in order to achieve optimal and
precise cutting results
Wood
Aluminium
Metal
Particle board
Plastic
Incorrect
Correct
TPI
Teeth per inch
Reciprocating saw
All manuals and user guides at all-guides.com
OPERATING INSTRuCTIONS
Always wear a dust mask.
INTENDED USE:
The machine is intended for sawing wood,
plastic, metal and building materials while
resting firmly on the workpiece. It is suitable
for straight and curved cuts.
ASSEMBLY AND OPERATION
Tool-less blade fitting
On/Off operation
Variable speed control
Wood cutting
Metal cutting
Plastic / Aluminum cutting
Flush cutting
Pivoting blade foot
adjustment
Pocket cutting
(soft materials only)
WORK HINTS FOR YOuR
RECIPROCATING SAW
If your power tool becomes too hot, set the
speed to maximum and run a no load for 2-3
minutes to cool the motor.
Always ensure the work-piece is firmly held or
clamped to prevent movement.
The blade guard must be held firmly against
the material being cut to reduce saw vibration,
blade jumping and blade breakage.
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional
NOTE: Before using the tool, read the
instruction book carefully.
action Figure
See Fig.A
See Fig.B
See Fig.C
See Fig.D1
See Fig.D2
See Fig.D3
See Fig.E
9
See Fig.F
See Fig.G
EN