Motorola NKN6610 Mode D'emploi

Replaceable Cable Assembly
NKN6610/NKN6611/NKN6614
Compatible Remote Speaker Microphones (RSM) include:
NMN6271, NMN6272, NMN6273, and NMN6274.
Accessories
*MN000543A03*
MN000543A03-AA
MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the Stylized M
logo are trademarks or registered trademarks of Motorola Trademark
Holdings, LLC and are used under license. All other trademarks are the
property of their respective owners.
© 2014 Motorola Solutions, Inc. All rights reserved.
Printed in Malaysia.
Cable Removal
To detach cable from Remote Speaker Microphone (RSM),
remove the screw completely before rotating the collar. Use
TORX 6IP (T6) tip screwdriver.
Note: Earlier versions of this cable may require you to insert a
thin tool under the screw head to aid in screw removal.
Cable Attachment
1. Align the cable connector with the RSM connector and
insert into RSM. Ridge on connector faces the front.
2. Hold the RSM with the front facing you, then position the
locking screw such that it faces the front.
3. Move the collar onto the RSM and rotate it into the locked
position. The locking screw should now be at the right side
of the RSM.
4. Tighten the screw using a TORX 6IP (T6) tip screwdriver.
Note: To avoid damage to screw head, do not overtighten.
(Maximum torque: 2 in-lbs).
en
RSM
Connector
Collar
Ridge towards
front
Screw