Publicité
Les langues disponibles
Les langues disponibles
SYM-
SIGNAL
BOL
CAUTION
3
INSTALLATION
3.1
ELECTRICAL CONNECTION
This machine has a precisely built electrical motor. It should
be connected to a power supply that is 120V, 60 Hz, AC only
(household). Do not operate this machine on direct current
(DC). A considerable voltage drop will cause a loss of power
and the motor will be overheated.
3.1.1
PREPARE A DRIP LOOP
Recommend the use of a drip loop as below so the water can
not run along the power cord even possibly reach the
electrical outlet and plug.
WARNING
Keep the extension cord clear of the working area. Position
the cord so that it will not get caught on lumber, tools, or
other obstructions while you are working with a power tool.
Failure to do so can result in serious personal injury.
3.2
INSTALLATION INSTRUCTIONS
3.2.1
UNPACK THE MACHINE
WARNING
Make sure that you correctly assemble the machine before
use.
WARNING
•
If the parts have damage, do not use the machine.
•
If you do not have all the parts, do not operate the
machine.
•
If the parts are damaged or missing, speak to the service
center.
English
MEANING
(Without Safety Alert Sym-
bol) Indicates a situation that
may result in property dam-
age.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
3.2.2
INSTALL THE WHEELS
1. Put an axle through the wheel and handle frame.
2. Attach a washer to the axle.
3. Put a cotter pin through the hole of the axle.
3.2.3
INSTALL THE GUN HOLDER
1. Aligh the screw sleeves of the gun holder with the screw
holes on the upper handle.
2. Push the screws through the screw sleeves and tighten
them.
3.2.4
INSTALL THE UPPER HANDLE
1. Push and hold the handle lock button on the upper handle.
2. Move the upper handle into the lower handle until the
handle lock button clicks through the slot.
7
EN
Publicité
