Publicité
Les langues disponibles
Les langues disponibles
For DBO481
NOTICE:
The cap may come out of the sanding
base while replacing the pad. Be sure to set the
cap back in the circular hole around the center of
the base before installing the optional pad.
2
Fig.11
► 1. Cap 2. Sanding base 3. Circular hole
1.
Loosen and remove the four screws securing the
pad to the sanding base.
Fig.12
► 1. Screws 2. Pad 3. Sanding base
2.
Replace the standard-equipped pad with an
optional hook-and-loop pad.
3.
Re-tighten the screws firmly to secure the hook-and-loop pad.
Fig.13
► 1. Abrasive paper 2. Pad 3. Dust-suction holes
4.
and-loop pad.
5.
paper to the pad, aligning the dust-suction holes in the
paper with those in the pad.
1
3
Fig.14
► 1. Abrasive paper 2. Pad 3. Dust-suction holes
6.
edge.
Using triangular/rectangular abrasive
1
paper
Optional accessory
2
loop pad correctly and securely. A loose attach-
ment will run out of balance and cause an excessive
vibration resulting in loss of control.
3
and abrasive paper are aligned and securely
attached.
papers. Never use pressure-sensitive abrasive
papers.
NOTICE:
base while replacing the pad. Be sure to set the
cap back in the circular hole around the center of
the base before installing the optional pad.
1
2
3
Fig.15
► 1. Cap 2. Sanding base 3. Circular hole
9 ENGLISH
Remove all dirt and foreign matter from the hook-
Attach a sheet of optional hook-and-loop abrasive
1
2
To remove the abrasive paper, peel it off from the
CAUTION:
Make sure to install a hook-and-
CAUTION:
Be sure that a hook-and-loop pad
CAUTION:
Only use hook-and-loop abrasive
The cap may come out of the sanding
2
3
1
3
Publicité
