Publicité
Les langues disponibles
Les langues disponibles
OPERATING YOUR HEATER
Once the stove has been properly assembled and connected to an electrical outlet, it is
ready to operate:
Open
the iron gate
1.Flame Function
2. Low Heat Setting
3. High Heat Setting
PREPARATION
Place the heater on a firm, level surface and plug into a 120V, 60Hz power outlet. Only
operate heater in upright position with caster wheels attached.
MAINTENANCE
1. Glass Information
* Under no circumstances should this product be operated with missing or broken glass.
* Do not strike or slam the glass.
* Do not use abrasive cleaners to clean the glass.
* Replacement glass is available from the manufacturer and replacement should be
carried out by a qualified service person.
Press power switch (#1) to the "on" position for flame function.
Note: This function can be used without heat.
For low heat function – Press(#2) switch while the (# 1) switch
is in the "on" position for low heat.
The low heat is 750W.
For high heat function -Press(#3) switch while both (#2) and
(#1) are in the "on" position for high heat.
The high heat is 1500W.
6
Publicité
