Epson TM-U295 Manuel D'utilisation page 7

4. Open the printer cover by first
pressing the ridges on the top
to the left slightly and then
pulling the cover forward, as
shown in illustration
5. If there is a used ribbon,
remove it by grasping the
handle and pull it straight out,
as shown by the arrow in
illustration
6. Before installing the new
ribbon, check that it is not creased or twisted. Then turn the feed knob
in the direction of the arrow on the ribbon cassette to take up any
slack in the ribbon.
7. Carefully insert the ribbon
cassette in the printer as shown
in illustration
where the ribbon must go.
8. Push firmly on the right side
and then the left side of the
ribbon cartridge until each side
clicks into place.
9. To put the cover back on the
printer, first align the left side
of the cover; then insert the tab on the top; then press the bottom until
it clicks into place (see illustration
Inserting Paper
Note:
Do not use wrinkled or curled paper. Be sure to use roll paper that meets the
specifications.
1. Make sure a ribbon cassette is installed in the printer.
2. Turn on the printer. The POWER light comes on.
3. Press the RELEASE button. The RELEASE light comes on to show that
the printer is in release mode. In this mode, paper can be inserted and
removed.
.
2
.
3
. Notice exactly
4
2
3
4
).
2
TM-U295/U295P User's Manual 7
English