Heath Zenith SL-7001 Mode D'emploi page 4

SYMPTOM
Lights will not come on.
Lights come on in daylight. 1. Light control may be installed in a relatively
Lights come on for no appar-
ent reason.
Lights stay on continuously. 1. Light control is pointed toward a heat source
Lights flash on and off.
Please call 1-800-858-8501 for assistance before returning product to store.
If you experience a problem, follow this guide. You may also want to visit our Web site at: www.desatech.com. If the
problem persists, call* for assistance at 1-800-858-8501, 7:30 AM to 4:30 PM CST (M-F). You may also write* to:
DESA Specialty Products™
ATTN: Technical Service Specialty Products
P.O. Box 90004
Bowling Green, KY 42102-9004
* If contacting Technical Service, please have the following information available: Model Number, Date of Purchase,
and Place of Purchase.
This is a "Limited Warranty" which gives you specific legal rights. You may also have other rights which vary from state to
state or province to province.
For a period of five years from the date of purchase, any malfunction caused by factory defective parts or workmanship will
be corrected at no charge to you.
Not Covered - Repair service, adjustment and calibration due to misuse, abuse or negligence, light bulbs, batteries, and other
expendable items are not covered by this warranty. Unauthorized service or modification of the product or of any furnished
component will void this warranty in its entirety. This warranty does not include reimbursement for inconvenience, installation,
setup time, loss of use, unauthorized service, or return shipping charges.
This warranty covers only DESA Specialty Products™ assembled products and is not extended to other equipment and
components that a customer uses in conjunction with our products.
THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY
WARRANTY, REPRESENTATION OR CONDITION OF MERCHANT ABILITY OR THAT THE PRODUCTS ARE FIT FOR
ANY PARTICULAR PURPOSE OR USE, AND SPECIFICALLY IN LIEU OF ALL SPECIAL, INDIRECT, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES.
REPAIR OR REPLACEMENT SHALL BE THE SOLE REMEDY OF THE CUSTOMER AND THERE SHALL BE NO LIABILITY
ON THE PART OF DESA SPECIALTY PRODUCTS™ FOR ANY SPECIAL, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL
DAMAGES, INCLUDING BUT NOT LIMITED TO ANY LOSS OF BUSINESS OR PROFITS, WHETHER OR NOT FORESEE-
ABLE. Some states or provinces do not allow the exclusion or limitation of incidental or consequential damages, so the above
limitation or exclusion may not apply to you. Proof of purchase is required for warranty claims.
All manuals and user guides at all-guides.com
TROUBLESHOOTING GUIDE
POSSIBLE CAUSE
1. Battery is dead.
2. Sensor is turned OFF.
3. Lamp is loose or burned out.
4. Daylight turn-off is in effect.
5. Incorrect aiming.
dark location.
2. Light control is in TEST.
1. Light control may be sensing small animals
or automobile traffic.
2. Range is set too high.
likeanairvent,dryervent,orbrightly-colored
heat-reflective surface.
2. Light control is in TEST.
1. Heat or light from the lamp may be turning
the light control on and off.
2. Heat being reflected from other objects
may be affecting the sensor.
3. Light control is in the TEST mode and
warming up.
4. Battery is almost dead.
TECHNICAL SERVICE
No Service Parts Available for this Product
FIVE YEAR LIMITED WARRANTY
SOLUTION
1. Switch the sensor OFF and let the battery
charge for three or more sunny days before
using again.
2. Turn sensor ON.
3. Check lamp and replace if burned out.
4. Recheck after dark.
5. Re-aim the sensor to cover desired area.
1. Relocate light control to an area that receives
more light.
2. Set control switch to AUTO position.
1. Re-aim sensor.
2. Reduce RANGE.
1. Reposition sensor.
2. Set control switch to AUTO position.
1. Reposition the lamps away from the sensor.
2. Reposition sensor.
3. Flashing is normal under these conditions.
4. Reduce RANGE. If flashing continues, switch
the sensor OFF and let the battery charge for
three or more sunny days before using again.
4 595-5291-07