Heath Zenith SL-5610 Installation

Motion Sensor
Entryway Light
Models SL-5610/15
The Heath
®
on up to 60 watts of incandescent light when motion
is detected and then, after a selectable time period,
automatically turns the light off. The built-in photocell
keeps the light off during daylight hours.
This package includes:
globe
(SL-5615)
Entryway Light
Mounting Nut and Stem
• The Entryway Light requires 120-volts AC.
• If you want to use Manual Override, the light must be
wired through a switch.
• Some codes require installation by a qualified
electrician.
© 2007 HeathCo LLC
Get user manuals: See SafeManuals.com
/Zenith Motion Sensor Entryway Light turns
Sensor
jar
or
(SL-5610)
Mounting Strap and
Grounding Wire
Requirements
Mode:
Test
Auto
Manual
* resets to Auto Mode at dawn.
Note: When first turned on wait about 1
the circuitry to calibrate.
Put the ON-TIME switch on the bottom
of the sensor in the TEST position.
Put the ON-TIME switch in the 1, 5,
or 10 minute position.
Manual mode only works at night
because daylight returns the sensor
to AUTO.
2 Screws
Flip the light switch off for one second
then back on to toggle between AUTO
and MANUAL MODE.
2 Wire Manual mode works only with the
Connectors ON-TIME switch in the 1, 5, or 10
position.
Mode Switching Summary
TEST
AUTO
MANUAL MODE
* If you get confused while switching modes, turn the
power off for one minute, then back on. After the cali-
bration time the control will be in the AUTO mode.
OPERATION
On-Time Works:
5 Seconds
1, 5, or 10 Min
Until Dawn*
1
TEST
AUTO
ON-TIME
10 5 1 TEST
MANUAL MODE
OFF then...
... back on.
Move ON-TIME Switch to
1, 5, or 10 minutes
Flip light switch off
for one second then
back on*
Day Night
x x
x
x
/ minutes for
2
ON-TIME
10 5 1 TEST
1 Second
595-5498-09