Black & Decker Quickset II BDSS100 Manuel D'instructions page 9

10. Rotate bracket (M), to the position shown in Fig.
12. Loosen lock handle (R) and insert holddown rod (S)
into hole in bracket (M), as shown.
11. Rotate bracket (M) Fig. 13, back to its original
position as shown, and tighten the two screws that
were loosened in STEP 9. Then tighten lockhandle (R)
to hold rod (S) in position.
12. Slide end of chip blower tube (T) Fig. 14, onto end
of air nozzle (V), as shown.
13. The tool holder (X) Fig. 15, is used to hold the
quickset blade changing wrench (Y), (for removing
blade from lower blade holder), 4mm allen wrench (W)
and extra blades (Z).
All manuals and user guides at all-guides.com
9
M S
R
Fig. 12
S
M
N
R
Fig. 13
T
V
Fig. 14
W
Z
Y
X
Fig. 15