Black & Decker Quickset II BDSS100 Manuel D'instructions page 8

All manuals and user guides at all-guides.com
6. Disassemble the handle by unscrewing and
re mov ing screw and spring (F), and handle (G) from
locking stud (H), as shown in Fig. 8. Place a M10 flat
washer (J) on threaded end of stud (H).
G
J
F
H
Fig. 8
7. Screw threaded end of stud (H) Fig. 9, with the M10
flat washer (J) through slot in angle of tilt scale (D) and
D
into tapped hole (K).
K
J
H
Fig. 9
8. Place handle (G) Fig. 10, onto locking stud (H) and
fasten with screw and spring (F). Move table (A) to the
A
horizontal position and lock table (A), by turning handle
(G) clockwise.
H
F
G
Fig. 10
9. Using the 4mm wrench (L) Fig. 11, loosen the two N
M
screws (P) on bottom of bracket (M) that fasten bracket
to rod (N).
P
L
Fig. 11
8