Publicité
Les langues disponibles
Les langues disponibles
6.
Press down the other end of the clip to fasten the cooling set on the top of the retention
mechanism.
7.
Locate the Fix Lever, Safety Hook and the Fixed Bolt. Lift up the intensive fixed lever.
8.
Fasten down the lever.
9.
Make sure the safety hook completely clasps the fixed bolt of the retention mechanism.
MSI Reminds You...
While disconnecting the Safety Hook from the fixed bolt, it is necessary to keep an eye on your
fingers, because once the Safety Hook is disconnected from the fixed bolt, the fixed lever will
spring back instantly.
Memory
The mainboard provides two 184-pin unbuffered DDR266/DDR333/DDR400 DDR SDRAM
sockets, and supports the memory size up to 2GB. To operate properly, at least one DIMM
module must be installed. (For the updated supporting memory modules, please visit
http://www.msi.com.tw/program/products/mainboard/mbd/pro_mbd_trp_list.php )
Install at least one DIMM module on the slots. Memory modules can be installed on the slots in
any order. You can install either single- or double-sided modules to meet your own needs.
Installing DDR Modules
1.
The DDR DIMM has only one notch on the center of module. The module will only fit in the
right orientation.
2.
Insert the DIMM memory module vertically into the DIMM slot. Then push it in until the
golden finger on the memory module is deeply inserted in the socket.
3.
The plastic clip at each side of the DIMM slot will automatically close.
Volt
Notch
6
Publicité
