Publicité
Les langues disponibles
Les langues disponibles
5. Install the Control Box
NOTE: Verify that the hose will reach the supply stop by attaching
the flex hose to the control box inlet.
Verify that the sensor cable is below the countertop.
Unthread the control box screws to remove the cover.
Position the control box over the hole for the spout tube and
sensor cables.
Drill pilot holes.
Use the standard wall anchors (provided) depending on your
wall material.
Feed the spout tube and sensor cables through the slot in the
control box.
Attach the control box to the wall with the arrow pointing
upward. Secure with the two screws (provided).
Kohler Co.
All manuals and user guides at all-guides.com
7
1386732-2-A
Publicité
