Beko MOB 20231 BG Mode D'emploi page 13

Installation and connection
3
3.1 Installation and
connection
• Remove all packing material and accessories.
Examine the oven for any damage such as dents
or broken door. Do not install if oven is damaged.
• Remove any protective film found on the
microwave oven cabinet surface.
• Do not remove the light brown Mica cover that
is attached to the oven cavity to protect the
magnetron.
• Select a flat surface that provides sufficient
space for inlet and outlet ducts.
30cm
20cm
20cm
20cm
min85cm
• Minimum installation height is 85 cm.
• Rear surface of the appliance should not be
placed against a wall. Leave a clearance of min.
30 cm above the oven; the minimum distance
between the oven and adjacent walls, if any,
should be 20 cm.
• Do not remove the spacers beneath the oven.
• Obstructing the inlet and outlet openings may
damage the oven.
• The appliance is fitted with a plug and must only
be connected to a properly installed grounded
socket.
• The mains voltage must correspond to the
voltage specified on the rating plate.
• If the plug is no longer accessible after
installation, an all-pole isolating switch must be
present on the installation side with a contact
gap of at least 3 mm.
• Adapters, multi-way sockets and extension
cords must not be used. Overloading can result
with a risk of fire.
Microwave Oven / User Manual
All manuals and user guides at all-guides.com
A
C
C
WARNING: Do not place the oven
onto a hob or any other appliance
that emits heat. Placing the oven
on or close to a heat resource may
damage the oven and consequently,
the warranty will become void.
The accessible surface may be hot
during operation.
Do not trap or bend the power cable.
For built-in use, refer to the
installation information contained
in kit with the model code
MOK 20232 X.
13 / EN