Télécharger Imprimer la page
Masquer les pouces Voir aussi pour MWDR24100SS:

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

Drawer Microwave
Installation Manual
MWDR24100SS
|
EN
FR
TINSKB300MRR1

Publicité

Chapitres

loading

Sommaire des Matières pour Beko MWDR24100SS

  • Page 1 Drawer Microwave Installation Manual MWDR24100SS TINSKB300MRR1...
  • Page 2: Table Des Matières

    CONTENTS 1 IMPORTANT SAFETY INSTRUCTIONS ......3 2 UNPACKING YOUR DRAWER MICROWAVE ....4 Important Notes to the Installer ......... 4 Important Notes to the Consumer ........4 3 INFORMATION YOU NEED TO KNOW ......5 Clearances and Dimensions ..........5 Grounding Instructions............
  • Page 3: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS IMPORTANT–Please Read and Follow • WARNING: If the information in this manual is not followed exactly, a fire or electrical shock • Before beginning, read these instructions thor- may result that could cause property damage, oughly and carefully. personal injury or death.
  • Page 4: Unpacking Your Drawer Microwave

    UNPACKING YOUR DRAWER MICROWAVE • Remove all packing materials from inside the Important Notes to the Installer Drawer Microwave. DO NOT REMOVE THE • Read all of the Installation Manual before in- WAVEGUIDE COVER, which is located on the stalling the Drawer Microwave. top of the appliance.
  • Page 5: Information You Need To Know

    INFORMATION YOU NEED TO KNOW GROUNDING Clearances and Dimensions • Dimensions that are shown in Figure 1 must INSTRUCTIONS be used. Given dimensions provide minimum clearance. Locate electrical outlet in the shad- ed area in the upper left-hand corner of the cut- This appliance must be grounded.
  • Page 6: Installation Instructions

    INSTALLATION INSTRUCTIONS Standard Mount and Measurements Figure 2 A. 21-5/8” (549.28 mm) B. 4-11/16” (119.06 mm) C. 1-3/4” (44.45 mm) D. 21-7/8” (555.60 mm) E. 23-7/8” (606.43 mm) Figure 1 F. 15-7/8” (403.22 mm) G. 14-19/32” (370.69 mm) A. 6” (152.40 mm) H.
  • Page 7: Flush Mount And Measurements

    INSTALLATION INSTRUCTIONS Flush Mount and Figure 3 represents a typical standard cabinet. If Measurements installed in custom cabinets with extended coun- tertops, take into account visibility and access to Prepare cabinet opening as shown in Figures 5, controls. See Figure 4. 6 &...
  • Page 8 INSTALLATION INSTRUCTIONS A. 22 ⁄ ” (562 mm) mounting cleat opening Parts Supplied width 2 Screws B. 0” flush C. 1 ⁄ ” (29 mm) front of cleat to cabinet face Flush Mount Deflector Vent (Stainless steel) Qty. 1 Top view Anti-Tip block Install deflector as shown in Figure 8A.
  • Page 9: Anti-Tip Block

    INSTALLATION INSTRUCTIONS Anti-Tip Block Electrical Outlet The electrical requirements are a 120 volt 60 Hz, Normal Installation Steps AC only, 15 amp. or more protected electrical supply. It is recommended that a separate circuit Anti-Tip Block Installation serving only this appliance be provided. Instructions The Drawer Microwave is equipped with a 3-prong •...
  • Page 10: Standard Mount Drawer Installation

    INSTALLATION INSTRUCTIONS Standard Mount Drawer 4. Carefully guide the drawer into the prepared opening. Avoid contact with the sides of the Installation cutout opening and also pinching the cord 1. Place the drawer adjacent to the wall or cabinet between the oven and the wall. opening.
  • Page 11 TABLE DES MATIÈRES 1 INSTRUCTIONS DE SÉCURITÉ IMPORTANTES ..12 2 DÉBALLAGE DU FOUR DRAWER MICROWAVE ..13 Remarques importantes pour l’installateur ..... 13 Remarques importantes pour le consommateur ..... 13 3 CE QUE VOUS DEVEZ SAVOIR ........14 Dégagements et dimensions ........... 14 Instructions pour la Mise à...
  • Page 12: Instructions De Sécurité Importantes

    INSTRUCTIONS DE SÉCURITÉ IMPORTANTES IMPORTANT - S’il vous plaît lire et suivre • ADVERTISSEMENT : Si l’on ne suit pas de près les indications dans ce manuel, il y a un • Prière de lire attentivement toutes ces direc- risque d’incendie ou de décharge électrique qui tives avant de commencer.
  • Page 13: Déballage Du Four Drawer Microwave

    DÉBALLAGE DU FOUR DRAWER MICROWAVE • Retirez tout le matériau d’emballage du Drawer Remarques importantes pour Microwave. N’ENLEVEZ PAS LE COUVER- l’installateur CLE DU GUIDE D’ONDES, qui se trouve sur le • Lisez tout le manuel d’installation avant d’in- dessus du Four Drawer Microwave. staller le Four Drawer Microwave.
  • Page 14: Ce Que Vous Devez Savoir

    CE QUE VOUS DEVEZ SAVOIR INSTRUCTIONS Dégagements et dimensions • Les dimensions indiquées au Schéma 1 POUR LA MISE À doivent être observées. Ces dimensions offrent un dégagement minimal. Repérer la prise élec- LA TERRE trique dans l’aire ombrée dans le coin gauche supérieur de la découpe.
  • Page 15: Instructions D'installation

    INSTRUCTIONS D’INSTALLATION Mesures pour le four montage standard et mesures Schéma 2 A. 21-5/8 po (549,28 mm) B. 4-11/16 po (119,06 mm) C. 1-3/4 po (44,45 mm) D. 21-7/8 po (555,60 mm) E. 23-7/8 po (606,43 mm) Schéma 1 F. 15-7/8 po (403,22 mm) A.
  • Page 16: Montage Encastré Et Mesures

    INSTRUCTIONS D’INSTALLATION Montage encastré et mesures La Schéma 3 représente une armoire de cuisine standard. Si l’appareil est installé dans une armoire Préparer l’ouverture de l’armoire comme illustré de cuisine faite sur mesure avec un dessus de aux Schémas 5, 6, 7. comptoir prolongé, veuillez tenir compte de la vis- A.
  • Page 17 INSTRUCTIONS D’INSTALLATION A. Ouverture avec tasseau de montage d’une Pièces fournies largeur de 22 ⁄ po (562 mm) 2 Vis B. Flush 0 po C. 1 ⁄ po (29 mm) à l’avant du taquet sur la Déflecteur de sortie pour montage encastré face de l’armoire (Acier inoxydable) Qté.
  • Page 18: Bloc Anti-Basculement

    INSTRUCTIONS D’INSTALLATION Bloc anti-basculement Prise de courant Le courant alimentation est 120 volts, 60 Hz, CA Étap es d’insta llation norma le seulement, 15 A ou plus et doit être protégé. Il est recommandé d’alimenter cet appareil par un Directives d’install ation du bloc circuit séparé.
  • Page 19: Installation De Tiroir Standard

    INSTRUCTIONS D’INSTALLATION Installation de tiroir standard 4. Guidez soigneusement le tiroir dans l’ouverture préparée. Évitez tout contact avec les côtés 1. Placer le four près de l’ouverture du mur ou de l’ouverture découpée et aussi de pincer le de l’armoire. Brancher le cordon ans la prise cordon entre le four et le mur.
  • Page 20 Mar 25, 2021...