Publicité
Les langues disponibles
Les langues disponibles
4
INSTALLATION INSTRUCTIONS
Anti-Tip Block
Normal Installation Steps
Anti-Tip Block Installation
Instructions
• To reduce the risk of tipping of the drawer, the
Anti-Tip block must be properly installed lo-
cated 14-13/16" above the floor on which the
appliance will sit. The 6" Anti-Tip block must
be provided by the installer. See Figure 9. The
Anti-Tip block prevents serious injury that might
result from spilled hot liquids.
• If the Drawer Microwave is ever moved to a
different location, the Anti-Tip block must also
be moved and installed. When installed to the
wall, make sure that the screws complete-
ly penetrate the dry wall and are secured in
wood or metal so that the block is totally stable.
When fastening, be sure that the screws do not
penetrate electrical wiring or plumbing.
Anti-Tip block
5" (127 mm)
4"
101.6 mm)
Drawer Microwave Oven / Installation Manual
6"
(152.4 mm)
3 1/2"
(89 mm)
Figure 9
Electrical Outlet
The electrical requirements are a 120 volt 60 Hz,
AC only, 15 amp. or more protected electrical
supply. It is recommended that a separate circuit
serving only this appliance be provided.
The Drawer Microwave is equipped with a 3-prong
grounding plug. It must be plugged into a wall
receptacle that is properly installed and grounded.
Should you only have a 2-prong outlet, have a
qualified electrician install a correct wall receptacle.
NOTE: If you have any questions about the
grounding or electrical instructions, consult a
qualified electrician or service person.
* Can also be installed using an electrical outlet
in an adjacent cabinet within the area where
the provided electrical cord can reach.
Always check electrical codes for requirements
penetrate electrical wiring or plumbing.
Suggested electrical
outlet location*
Figure 10
Anti-Tip
5" (127 mm)
4"
(101.6 mm)
9 / 19 EN
Publicité
Chapitres
