Barrette rdi Serie Manuel D'installation page 4

5.
Place rail with brackets between posts as shown in
Figure 7.
Pre-drill the holes (Fig. 8) for the mounting brackets
to avoid stripping the stainless steel screws and
secure in place using the rail mounting screws
(item I) from component list (Fig. 9).
NOTE: The looped part of the aluminum P-channel
must be facing away (down) from the baluster holes
while the flat side of the P-channel must be facing
the outside of the deck when mounted.
6.
Insert a baluster into each routed hole of the
bottom rail (Fig. 10).
NOTE: Each kit with vinyl balusters contains 2
tabbed balusters; space them evenly into each
section.
7.
Cut the top rail following the same procedure that
you used in steps 3 and 4 for the bottom rail.
8.
Place a T-shaped top mounting bracket (item F) on
each end of the top rail, with the flat side facing the
mounting surface.
Make sure that the aluminum T-channel is flush
with the end of the vinyl top rail (Fig. 11).
4
Fig. 7
Fig. 8
Fig. 9
Fig. 10