Black & Decker PRO Serie Mode D'emploi page 5

e. Do not overreach. Keep proper footing and balance
at all times. This enables better control of the power tool
in unexpected situations.
f. Dress properly. Do not wear loose clothing or
jewellery. Keep your hair, clothing and gloves away
from moving parts. Loose clothes, jewellery or long hair
can be caught in moving parts.
g. If devices are provided for the connection of dust
extraction and collection facilities, ensure these are
connected and properly used. Use of these devices
can reduce dust related hazards.
4. Power tool use and care
a. Do not force the power tool. Use the correct power
tool for your application. The correct power tool will do
the job better and safer at the rate for which it was
designed.
b. Do not use the power tool if the switch does not turn
it on and off. Any power tool that cannot be controlled
with the switch is dangerous and must be repaired.
c. Disconnect the plug from the power source and/or
the battery pack from the power tool before making
any adjustments, changing accessories, or storing
power tools. Such preventive safety measures reduce
the risk of starting the power tool accidentally.
d. Store idle power tools out of the reach of children
and do not allow persons unfamiliar with the power
tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained
users.
e. Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and any
other condition that may affect the power tools
operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly
maintained power tools.
f. Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
5. Service
a. Have your power tool serviced by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the power tool is
maintained.
All manuals and user guides at all-guides.com
6. Electrical safety
corresponds to the voltage on the rating plate.
Warning! If the power cord is damaged, it must be replaced
by the manufacturer, authorized Black & Decker Service
Center or an equally qualified person in order to avoid
damage or injury. If the power cord is replaced by an equally
qualified person, but not authorized by Black & Decker, the
warranty will not be valid.
7. Labels on tool
The label on your tool may include the following symbols:
V ........ Volts
A ........ Amperes
Specific safety rules
• Adjust the cutting depth to the thickness of the
workpiece. Less than a full tooth of the blade teeth
should be visible below the workpiece
• Do not reach underneath the work. The guard can not
protect you from the blade below the work.
Lower guard function
• Check lower guard for proper closing before each
use. Do not operate the saw if lower guard does not
move freely and close instantly. Never clamp or tie
the lower guard into the open position.
• Check the operation of the lower guard spring. If the
guard and the spring are not operating properly, they
must be serviced before use.
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
Read Hz ....... Hertz
Instructions
W ....... Watts
Manual
min ..... minutes
Use Eye
Protection
..... Alternating
Current
Use Ear
Protection
..... Direct
Current
n ....... No-Load
0
Speed
ENGLISH
...... Class II
Construction
...... Earthing
Terminal
...... Safety
Alert Symbol
.../min.. Revolutions
or Recipro-
cation per
minute
5