Publicité
Les langues disponibles
Les langues disponibles
Frost Precautions
Avoid placing the dishwasher in a location where the temperature is below 0°C. If this is
unavoidable, empty the dishwasher, close the door, disconnect the water inlet pipe and
empty it.
TROUBLESHOOTING
Problem
Dishwasher
Fuse blown, or the
will not start.
circuit breaker
tripped
Power supply is not
turned on.
The door has not
been properly
closed.
Water not
Kink in drain hose
pumped from
Filter clogged
dishwasher
Kitchen sink clogged
Suds in the tub Improper detergent
Spilled rinse aid
Stained tub
Detergent with
interior
colourant is used.
White film
Hard water minerals
over the inside
surface
There are rust
The cutlery is not
stains on the
corrosion resistant.
Possible Causes
Solutions
Replace fuse or reset circuit breaker.
Remove any other appliance sharing the
same circuit with the dishwasher.
Make sure the dishwasher is turned on
and the door is closed securely.
Make sure the power cord is properly
plugged into the wall socket.
Close the door securely.
Check drain hose.
Check the filters (see "Cleaning the Filter
Unit").
Check kitchen sink to make sure it is
draining well. If kitchen sink is not
draining, you may ask a plumber to
check it.
Use only the detergent special for
dishwasher to avoid suds. If this occurs,
open the door and let the suds
evaporate. Close the door securely then
start the soak wash cycle to drain the
water out. Repeat if necessary.
Always wipe up rinse aid spills
immediately.
Make sure the detergent does not
contain any colourant.
To clean the interior, use a damp sponge
with dishwasher detergent and wear
rubber gloves.
Never use any other cleaner than
dishwasher detergent for the risk of
foaming or suds.
2 1
Publicité
