Publicité
Les langues disponibles
Les langues disponibles
BEFORE INSTALLING YOUR DISHWASHER
Before connecting your dishwasher to the power supply, check that the voltage
stated on the rating label of your appliance corresponds to the voltage in your home.
The appliance must be grounded. The manufacturer is not responsible for damages
that may occur as a result of usage without grounding.
WARNING: Disconnect electrical power before installing your dishwasher.
INSTALLATION INSTRUCTIONS
Your dishwasher can be installed in various locations in your kitchen as long as there is
space and accessibility to connect your dishwasher to the water/drainage and electrical
supply.
Do not connect an extension lead to the appliance to avoid potential safety hazards.
Connecting to the Mains Water Supply
Inlet hose (Cold water supply)
Water Pressure
For best operating results, incoming water pressure should be between 0.04 MPa and
1MPa. Incoming water supply for the dishwasher is controlled by a 'pressure switch', so if
the household water pressure is low, dishwasher fill time will increase or may not operate.
WARNING: Please close the hydrant after using.
Connecting to the water outlet
Insert the drain hose into a drainage pipe or standpipe.
The end of the hose should be dropped into a drainage pipe, the maximum height of which
should be 1000 mm above the base of the dishwasher. The end of the hose must not be
immersed in water to avoid the back flow of it.
To allow for an air gap around the end of the drain hose, the diameter of the standpipe
should be at least 40 mm.
The water inlet hose from the machine terminates in a 3/4" female
connector. The water supply should therefore terminate in a similar
male connector and should have a stopcock close by in the pipe.
Connect the straight connector of the inlet hose to the water supply
securely ensuring that the washers are securely in place at both
ends of the hose.
8
Publicité
