Publicité
LEG STAND ASSEMBLY
INSTRUCTIONS
Required Tools
7/16" Socket
Philips Head Screw Driver
13/16" Open End Wrench
Leg
assembly
Shelf
Figure 1
1. Insert short end of leg into top of shelf
(Fig. 1).
2. Secure into place with one (1) screw, one
(1) lock washer, and one (1) nut per hole.
3. Repeat leg installation with three (3)
remaining legs.
Non-locking
Locking casters
(front)
Figure 2
4. Install the two (2) front locking casters into
the short end of the leg assembly (Fig. 2).
All manuals and user guides at all-guides.com
Screw
Nut
w/
Lock
washer
casters
(rear)
5. Install the rear non-locking casters into
the remaining two (2) leg assemblies.
6. Secure all four (4) casters by tightening
down the nut on the underside of the
caster.
7. Ensure the two locking casters are located
on the same side of the stand. This will
now be the front of the broiler.
BROILER STAND INSTALLATION
Required Tools
13/16" Open End Wrench
1. Lower Broiler onto the four (4) legs of the
stand, supporting from under the body
bottom (Fig. 4).
— 5 —
Tighten nut
Figure 3
Figure 4
Publicité
