Publicité
Les langues disponibles
Les langues disponibles
Reversing the door
Brief introduction
The side at which the door opens can be
changed from the right side (as supplied) to the
left side, if the installation site requires.
Tools you will need:
1. 8mm socket driver
2. Cross-shaped screwdriver
3. Putty knife or thin-blade screwdriver
Before you start lay the refrigerator on it's back in
order to gain access to the base, you should rest
it on soft foam packaging or similar material to
avoid damaging the cooling pipes at the rear of
the refrigerator.
① screw hole cover
③ upper hinge cover
⑤
freezing door
⑦
special flange self-tapping screw
1. Open the appliance door and unhinge and remove all fittings from inside the appliance.
2. Remove the upper hinge cover (3).
3. Remove the two screws (2) that connect the upper hinge part (4) on the right side of the cabinet top.
4. Carefully lift the door and place it on a padded surface to prevent scratching.
5. Remove the screw hole cover (1) and transfer it to the uncovered hole on the right side of the unit.
Be sure to press the button firmly into the hole.
6. Remove the two screws (7) that hold the lower hinge parts (6) on the right side of the unit.
7. Remove the supporting leg (8) and transfer it to the right side as shown in the adjacent figure.
8. Set the door into its new place making sure the pin enters the bushing at the lower frame section
(hole).
9. Secure the upper hinge part (4) previously removed in step 4 on the left side of the unit. Make sure
the pin enters the bushing on the upper frame section (hole).
10. Loosely secure the lower hinge parts (6) and do not tighten the bolts until the door is in the closed
position and leveled.
11. Replace the upper hinge cover (3).
12. Turn the appliance upright again.
13. Open the appliance doors and attach all fittings.
13
② special flange self-tapping screw
④ upper hinge part
⑥
lower hinge parts
⑧
supporting leg
Publicité
