BALDR B0360WST2H2PR-V1 Mode D'emploi page 10

All manuals and user guides at all-guides.com
Powered by batteries:
1. Remove the battery compartment cover.
2. Insert 3x AAA batteries matching the polarity(+and-)
3. Replace the battery cover
SENSOR INSTALLATION
1. Remove the battery compartment cover
2. Insert 2xAA batteries matching the polarity（+and-)
3. Replace the battery cover
SENSOR SETUP
● Power the main unit prior to load the battery of sensor
● Switch the Channel 1 -2- 3 of the senor to any channel you want.
For example, you can set to Channel 1 for the sensor. But please
ensure the main unit are set to the same channel before
synchronization. (Special note: Press."▲/CH'' button on the main
unit to set the channel.The setting order is CH1--CH2--CH3--
Channel scan（from CH1 to CH2 to CH3,8 seconds intervals）,
you must select the same number choices for both the sensor and
the main unit in order to synchronize)
● Auto synchronization: after power on both units, the receiving
status will last for max 3 minutes,the receiving antenna signal will
flash, if no signal received in 3 minutes, the antenna signal will
disappear and stop receiving outdoor signal.
● If the main unit is out of 3 minutes'signal receiving window, you
need to press and hold the "▲/CH''button to enter into signal
receiving again.
10