Black & Decker PRO Serie Mode D'emploi page 4

ENGLISH
e. Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and any
other condition that may affect the power tools
operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly
maintained power tools.
f. Use the tool in accordance with these instructions
and in the manner intended for the particular type of
power tool, taking into account the working
conditions and the work to be performed. Use of the
power tool for operations different from those intended
could result in a hazardous situation.
5. Service
a. Have your power tool serviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the power tool is
maintained.
6. Labels on tool
The label on your tool may include the following symbols:
Read Hz ....... Hertz
Instructions
W ....... Watts
Manual
min ..... minutes
Use Eye
Protection
..... Alternating
Current
Use Ear
Protection
..... Direct
Current
V ........ Volts
A ........ Amperes n ....... No-Load
0
Speed
S2 ........ The short
20min time duty
Additional Safety Rules For Bench Grinders
• Value of the thickness limit of wear of the work rest is
1 mm.
• Always use proper guard with grinding wheel. A guard
protects operator from broken wheel
• Accessories must be rated for at least the speed
recommended on the tool warning label. running over
the rated speed can fly apart and cause injury.
4
All manuals and user guides at all-guides.com
...... Class II
Construction
...... Earthing
Terminal
...... Safety
Alert Symbol
.../min.. Revolutions
or Recipro-
cation per
minute
is 20 min
• Before using, inspect recommended accessory for cracks
or flaws. If such a crack or flaw accessory. Do not use a
grinding wheel that is cracked or flawed in any
• When starting the tool, let it run for one minute. Never
start the tool with a person in line the operator.
• Do not grind on the sides of grinding wheels unless they
are specifically designed for that
• Do not overtighten wheel clamp nut. This may crack the
grinding wheel.
• Clean the cavity around the grinding wheel periodically.
Warning: Some dust created by power sanding,
sawing, grinding, drilling, and other construction
activities contains chemicals known to cause
cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other
masonry products, and arsenic and chromium from
chemically-treated lumber. (CCA)
Your risk from these exposures varies, depending on how
often you do this type of work. To reduce your exposure to
these chemicals: work in a well ventilated area, and work with
approved safety equipment, such as those dust masks that
are specially designed to filter out microscopic particles.
• Wear protective glasses;
• Do not use damaged or misshapen wheels or brushes
• The adjustment of the spark arrestor shall be made
frequently, so as to compensate the wear of the wheel,
keeping the distance between the guard and the wheel as
small as possible, but in any case not greater than 2mm;
• The adjustment of the work rest shall be done gradually
so as to compensate the wear of the wheel, keeping the
distance between the work rest and the wheel as small as
possible, but in any case not greater than 2mm;
Bench Mounting
1. The grinder should be unplugged.
2. Position grinder on workbench. Check for the availability
of power for the grinder. Mark location of holes for drilling.