Publicité
Les langues disponibles
Les langues disponibles
Fig. 2
Turn off power at breaker box to
avoid possible electric shock.
REMEMBER to turn off the power. Follow the steps below to
hang your fan properly.
1. Remove the clevis pin, cotter pin and set screws from the top
of the motor assembly (see Fig. 5).
2. Route wires exiting from the top of the fan motor through the
coupling cover, canopy and then through the ball/downrod
(see Fig. 5).
NOTE: If a longer downrod (not included) is needed, take out
the screw located in the hanger ball, lower the hanger ball and
remove the pin, remove all 3 pieces from the downrod and
assemble them onto the new longer downrod before proceeding
to step 2.
3. Align the holes at the bottom of the downrod with the holes in
the coupling on top of the motor housing (see Fig. 5). Carefully
insert the clevis pin through the holes in the collar and
downrod. Be careful not to jam the clevis pin against the
wiring inside the downrod. Insert the cotter pin through the
hole near the end of the clevis pin until it snaps into its locked
position, as noted in the circle inset in Fig. 5.
Warning: Failure to properly install cotter pin as noted in
!
step 3 could result in fan loosening and possibly falling.
4. Tighten two set screws at top of the fan motor collar firmly
and evenly (see Fig. 5).
5. Carefully lift the fan assembly up to the ceiling mounting
bracket and seat the hanger ball in the mounting bracket
socket. Make sure the tab on the mounting bracket socket is
properly seated in the groove in the hanger ball (see Fig. 6).
This will help to balance the ceiling fan.
6. Secure the safety cable to the building structure using a hook
screw (included).
Warning: The tab in the ring must rest in the groove of the
!
hanger ball as in Fig. 6. Failure to properly seat the tab in the
groove could cause damage to wiring.
All manuals and user guides at all-guides.com
Installing Your Fan
Fig. 3
Use metal outlet box (sold separately)
suitable for fan support. Secure outlet box
directly to the building structure using wood
screws (included). Outlet box must support
35 lb (15.9 kg) minimum.
Hanging the Fan
5
Outlet box
Mounting bracket
Mounting screws
Install mounting plate to outlet box
in the ceiling using the mounting
screws provided with the outlet box.
Motor wires
Canopy
Ball/downrod
assembly
Cotter pin
Set screws
Fig. 5
Safety cable
Groove
Fig. 6
Fig. 4
Pin in locked
positioon
Coupling cover
Motor collar
Clevis pin
Tab
Publicité
