NOMA Estate 52 Manuel D'instructions page 2

Safety Rules–Read and Save These Instructions
1. To reduce the risk of electric shock, ensure electricity has been turned off at the circuit breaker or fuse box before installing.
2. All wiring must be in accordance with the national and local electrical codes. Electrical installation should be performed by a
qualified licensed electrician.
3. WARNING: To reduce the risk of electrical shock or fire, do not use this fan with any solid-state fan-speed control device. It will
permanently damage the electronic circuitry.
4. CAUTION: To reduce the risk of personal injury, use only the screws provided with the outlet box.
5. The outlet box and support structure must be securely mounted and capable of reliably supporting a minimum of 35 lb (15.9 kg).
Use only UL listed outlet boxes marked "FOR FAN SUPPORT."
6. The fan must be mounted with a minimum of 7' (2.13 m) from the trailing edge of the blades to the floor.
7. Avoid placing objects in the path of the blades.
8. To avoid personal injury or damage to the fan and other items, be cautious when working around or cleaning the fan.
9. Do not use water or detergents when cleaning the fan or fan blades. A dry dust cloth or lightly-dampened cloth will be suitable for
most cleaning.
10. After making electrical connections, spliced conductors should be turned upward and pushed carefully up into the outlet box. The
wires should be spread apart with the grounded conductor and the equipment-grounding conductor on one side of the outlet box
and the ungrounded conductor on the other side of the outlet box.
11. All set screws must be checked and retightened where necessary before installation.
Warning: To reduce the risk of fire, electric shock or personal injury, mount fan to outlet box marked "acceptable for fan support" with
!
the screws provided with the outlet box.
Warning: To reduce the risk of personal injury, do not bend the blade arms (also referred to as flanges), when installing the brackets,
!
balancing the blades, or cleaning the fan. Do not insert foreign objects between rotating fan blades.
Warning: To reduce the risk of fire, electric shock, or personal injury, mount to outlet box marked "acceptable for fan support of 35 lb
(15.9 kg) or less" and use mounting screws provided with the outlet box. Most outlet boxes commonly used for the support of light
!
fixtures are not acceptable for fan support and may need to be replaced. Due to the complexity of the installation of this fan, a qualified,
licensed electrician is strongly recommended.
Attention: This product is equipped with a 190 W limiting device. If lamping exceeds 190 W the light kit will shut off automatically
until the proper wattage of bulbs is installed. Reset the light kit by turning it off, replacing the bulbs with the correct wattage, and then
!
turning the light kit back on.
IC ID: 4529A-FANHD
Operation is subject to the following two conditions:
!
(1) This device may not cause interference; and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
All manuals and user guides at all-guides.com
2