Playing Other Sources; Choosing The Input Signal; Selecting The Multichannel Analog Inputs - Pioneer VSX-518 Mode D'emploi

05 Listening to your system

Playing other sources

1 Turn on the power of the playback
component.
2 Turn on the power of the receiver.
3 Select the source you want to playback.
Use the MULTI CONTROL buttons (INPUT
SELECTOR).
4 Start playback of the component you
selected in step 1.

Choosing the input signal

• Default setting: AUTO
You need to hook up a component to both
analog and digital inputs on the rear of the
receiver to select between input signals.
1 Press RECEIVER on the remote control.
2 Press SIGNAL SEL ( SIGNAL SELECT) to
select the input signal corresponding to the
source component.
Each press cycles through the following:
• AUTO – This automatically switches to
DIGITAL if a digital source is detected,
otherwise it remains on ANALOG.
• ANALOG – Selects the analog inputs.
• DIGITAL – Selects the digital input.
When set to DIGITAL or AUTO, 2 DIGITAL
lights when a Dolby Digital signal is input, and
DTS lights when a DTS signal is input.
Note
1 • This receiver can only playback Dolby Digital, PCM (32 kHz to 96 kHz), DTS and WMA9 Pro digital signal formats. With other
digital signal formats, set to ANALOG.
• You may get digital noise when a LD or CD player compatible with DTS is playing an analog signal. To prevent noise, make
the proper digital connections (page 9) and set the signal input to DIGITAL.
• Some DVD players don't output DTS signals. For more details, refer to the instruction manual supplied with your DVD player.
2 During playback from the multichannel inputs, you can't use any of the sound features/modes and only the volume and
channel levels can be set.
30
En
Selecting the multichannel
analog inputs
If you have connected a decoder or a DVD
player with multichannel analog outputs to this
receiver (page 10), you must select the analog
multichannel inputs for surround sound.
• Press DVD 5.1 ( SHIFT + TV CTRL ) on the
remote control or DVD 5.1 on the front panel.
To cancel playback from the multichannel
inputs, use the INPUT SELECTOR buttons to
select a different input signal.
1
2