Télécharger Imprimer la page

Uline H-9188 Mode D'emploi page 4

Publicité

Les langues disponibles

Les langues disponibles

9. Place left door and right door panels on a smooth,
non-marring surface to prevent scratching. Align
holes in hinge (D) with pre-drilled holes in door
panel. Insert two M4 x 10 mm screws and tighten
using a Phillips head screwdriver or drill. Repeat for
three remaining hinges. (See Figure 8)
10. Attach handles (C) to the outside of the door panels
using M4 x 22 mm screws and a Phillips head
screwdriver. (See Figure 8)
Figure 8
D
Left Door
11. Align holes on S-bracket (E) with pre-drilled holes on
left door. Insert two M3 x 12 mm screws and attach
using a Phillips head screwdriver or drill. (See Figure 9)
12. Align holes on lock (E) with pre-drilled holes on right
door. Insert two M3.5 x 16 mm screws (E) and attach
using a Phillips head screwdriver or drill. (See Figure 9)
Figure 9
Unlocked
Locked
Left Door
PAGE 4 OF 15
ASSEMBLY CONTINUED
Right Door
Right Door
E
13. Using two people, hold door panel in line with
side panel. Attach hinge to side panel using four
M4 x 14 mm screws. Repeat for three remaining
hinges. (See Figure 10)
Figure 10
C
14. Once door panels are attached, each hinge may
need to be adjusted to align the doors. To adjust
the depth of the doors, tighten or loosen the rear
screw in the hinge. To adjust the angle of the doors,
tighten or loosen the center screw in the hinge.
(See Figure 11)
Figure 11
E
Side
Panel
Door
Door Depth
Side
Panel
Door
Door Angle
0723 IH-9188

Publicité

loading