Uline H-9188 Mode D'emploi page 3

4. Insert cam lock pins (A) and dowels (F) into left side
panel. Insert cam locks (B) into bottom panel, back
panel and skirt panel. Attach bottom and back
panels and tighten cam locks using a Phillips head
screwdriver. (See Figure 4)
5. Insert adjustable glides (G) into bottom of side
panels. (See Figure 4)
Figure 4
Left Side
Panel
G
6. Align holes on L-bracket (E) with pre-drilled holes in
top panel. Insert two M3 x 12 mm screws and attach
using a Phillips head screwdriver or drill. Align holes
on plug (J) with pre-drilled holes in top panel and
gently tap with a rubber mallet to insert.
(See Figure 5)
Figure 5
Top
Panel
PAGE 3 OF 15
ASSEMBLY CONTINUED
A
F
B
E J
7. Insert cam lock pins (A) and dowels (F) into top
panel. Insert cam locks (B) into back panel, right
side panel and left side panel. Attach top panel
and tighten cam locks using a Phillips head
screwdriver. (See Figure 6)
Figure 6
8. Place cabinet upright. Insert shelf dowels (H) into
side panels. Place shelves inside cabinet and
ensure shelf supports lower onto shelf dowels.
Tighten shelf supports in underside of shelves for a
secure fit. (See Figure 7)
Figure 7
Top
Panel
B
F
A
Shelf Support
H
0723 IH-9188