Uline H-9188 Mode D'emploi page 2

NOTE: Assemble unit on a smooth, non-marring
surface to prevent scratching. Check that all
parts are included.
IMPORTANT! Turn cam lock 1/4 to the right to
lock. Ensure the arrow is pointing to edge of
panel before inserting into the panel's hole.
IMPORTANT! FUNCTION OF CAM LOCK
Ensure the arrow is pointing upwards
before inserting into the panel's hole.
IMPORTANT! Cam lock pins must be tightened
once inserted into panel. To tighten cam lock
pins, grasp lower part of cam lock pin and
tighten using a Phillips head screwdriver.
TIGHTENING OF CAM LOCK PINS
1. Insert cam lock pin (A) into bottom panel. Insert
cam lock (B) into skirt panel. Attach skirt panel and
tighten cam lock using a Phillips head screwdriver.
(See Figure 1)
NOTE: Cam lock caps (I) can be applied once
cam locks are tightened for a finished look.
Figure 1
PAGE 2 OF 15
1/4 RIGHT TURN
FOR LOCKING
Hold when
tightening
Skirt Panel
B
Bottom Panel
A
B
A
A
ASSEMBLY
2. Insert cam lock pins (A) and dowels (F) into back
panel. Insert cam locks (B) into bottom panel. Attach
bottom panel and tighten cam locks using a Phillips
head screwdriver. (See Figure 2)
Figure 2
Back Panel
3. Insert cam lock pins (A) and dowels (F) into right side
panel. Insert cam locks (B) into bottom panel, back
panel and skirt panel. Attach bottom and back
panels and tighten cam locks using a Phillips head
screwdriver. (See Figure 3)
Figure 3
Bottom
Panel
B
Bottom Panel
B
F
A
Back
Panel
Right Side
Panel
A
F
0723 IH-9188