fitmix livington PURE HEALTH Mode D'emploi page 7

4. Place the pitcher (D) on the power unit (G) and twist until the
pitcher locks into place. Make sure that the spout lever (F) is in
the OFF-position (H).
5. Place the ingredients into the pitcher (D). We recommend ad-
ding solid ingredients first and adding liquids second. You can
use fruits, fresh yoghurt, milk, juice, vegetables, etc. You can
also add ice or frozen ingredients to the pitcher, for example
frozen fruit, frozen yoghurt or ice cream. Tip: When using hot
or frothy liquids (e.g., milk) or frozen ingredients, the pitcher
should only be filled up to the 1000 ml mark.
6. Place the lid (C) on the blender jug (D) before plugging
the device in.
7. Connect the unit to the power supply.
8. Either put the measuring cup (B) into the lid (C) or place the
stirrer (A) in the hole. Tip: The stirrer can be used when blending
thick mixtures or when large quantities of frozen items are used.
9. 9. Press button 2 (L) for up to 30 seconds to begin the mixing
process, then press the 0 key / Pulse (J) (pulse mode) in short
intervals and let the ingredients mix together until evenly
puréed. Switch the device off. Tip: Use the plunger to push the
ingredients from the top into the liquid at the bottom.
10. There are two ways to pour the liquid: Option 1: Lift the blender
jug (D) off the motor unit (G) with a twisting motion, remove the
lid and pour the liquid into a container.
(2) You place a container underneath the spout (E) and press
the lever (F) down into the ON-position (I). When the container
is full, lift the lever (F) up into the OFF-position (H). Tip: to help
dispense thick liquids, press the 1 button (K) and then press
the spout lever (F) down into the ON-position (I). Thinner li-
quids may dispense without having to switch on the power unit.
MINI MIXER
With the Mini Mixer, you can grind spices, nuts, herbs, cheese,
coffee and much more. Attention: Only grind dry ingredients (e.g.,
spices, nuts) in the Mini-Mixer, never in the pitcher.
1. Place the Mini-Mixer attachment (N) on the power unit (G).
Make sure that the rubber knobs (O) of the Mini-Mixer attach-
ment (N) are correctly aligned with the indentations (P) of the
power unit (G).
2. Place the items to be ground into the Mini-Mixer attachment
(N). Fill it to 3/4 capacity only.
3. Place the Mini-Mixer lid (M) onto the power unit (G) and twist
until it locks into place.
4. Connect the unit to the power supply.
5. Press the 2 button (L) for up to 10 seconds to start the grinding
process. Afterwards press the 0/Pulse button (J) and continue
until the items are ground to the desired fineness.
6. Turn and lift the Mini-Mixer lid (M) off the power unit (G). Lift
the Mini-Mixer attachment (N) off the power unit and pour the
ground ingredients into a container.
Safety shutdown: The blender is constructed to work only with
an attached mixing container.
Note
• Always blend dry ingredients (e.g., spices, nuts) in the Mini-Mi-
xer and never in the pitcher.
• Never run the blender when it is empty.
• Never run the blender continuously for longer than 60 seconds.
• Don't use the blender as a storage container. Keep it empty
before and after each use.
• Avec quelques liquides comme par exemple le lait, le volume
augmente pendant le mixage et de la mousse peut se former.
Ne remplissez pas trop le récipient du mixer (max. 1 litre) et
assurez-vous que le couvercle est correctement en place.
• Never blend food that has formed a solid mass during freezing.
Break it up before adding it to the pitcher.
Practical tips:
• Before fitting the lid, use the stirrer to push the solid ingre-
dients into the liquid.
• Use the 0/Pulse button to operate the power unit in a start stop
action to control the texture of your drink. Take care as this
automatically selects the higher speed and may cause the liquid
to be thrown up the sides and onto the lid of the pitcher.
• Some liquids may separate on standing; therefore, it is best
to drink them right away. Separated drinks should be stirred
before drinking.
• To make a thinner smoothie drink, add more liquid. To make a
thicker smoothie drink, add more frozen ingredients. To help
dispense the last amount of a thick smoothie drink, add a few
tablespoons of liquid to increase the flow.
CLEANING
1. Fill the pitcher (D) halfway with warm water.
Tip: If the jug is very dirty, add a few drops of detergent
2. Fit the lid (C) and the cap (B) onto the pitcher (D) and then
place it on the power unit (G).
3. Press the 1 button (K) and whilst running, open the spout
(ON-position (I)) and allow the water to drain into a container
to clean the valve. Repeat until the water runs clear.
4. Afterwards, you can place the pitcher (D), the lid (C), the cap
(B) and the stirrer (A) in the dishwasher for cleaning .
Note
• Never let the power unit, cord or plug get wet.
• Always clean immediately after use.
• Do not let food dry onto the pitcher as this will make cleaning
difficult.
• Please do not attempt to remove or sharpen the knife. This may
degrade its performance.
Tip: Underneath the motor unit you will find a cable storage area.
Mini Mixer
It is safe to clean the Mini-Mixer attachment and the Mini-Mixer
lid in the dishwasher.
Power unit
Wipe with a damp cloth and then dry.
WARNING
Before cleaning, always switch off and unplug the appliance.
Cleaning the spout
The spout should be dismantled regularly for thorough cleaning.
1. Unscrew the spout (F) from the pitcher (D).
2. Dismantle the spout (E) by unscrewing the cap (Q) from the
connection valve (R).
3. Rinse the cap (Q) and the connection valve (R) with water and
mild detergent, then dry thoroughly.
4. Reassemble the spout (E) by reversing the above procedure.
Make sure that the gasket is properly installed on the pitcher
(D).
WARRANTY
Not included in the warranty are damages that have arisen due
to improper handling, e.g., overheating, discoloration, scratching,
damages caused by dropping it on the floor, unauthorized repairs
and improper cleaning. Excluded are also purely visual signs of
wear and tear or wear and tear in general.
DISPOSAL AND TECHNICAL DATA
Environmental instructions
Do not dispose this product at the end of its service life
through normal domestic waste. It has to be disposed
through a collection agency that recycles electric and
electronic devices. This is pointed out by the symbol on the
product, in the instruction manual, and on the packaging.
Please inquire about local collection agencies that may be
operated by your distributor or your municipal administration. By
7