Makita M5801 Manuel D'instruction page 8

hex bolt counterclockwise. Then remove the hex bolt,
outer flange and blade.
3
2
4
1
013546
To install the blade, follow the removal procedure in
reverse. BE SURE TO TIGHTEN THE HEX BOLT
CLOCKWISE SECURELY.
For tool with the inner flange for a 15.88 mm hole-
diameter saw blade
1 2
3
011231
Mount the inner flange with its recessed side facing
outward onto the mounting shaft and then place saw
blade, outer flange and hex bolt.
BE SURE TO TIGHTEN THE HEX BOLT CLOCKWISE
SECURELY.
For tool with the inner flange for a other than
15.88 mm hole-diameter saw blade
1 2
3
011230
The inner flange has a certain diameter protrusion on
one side of it and a different diameter protrusion on the
other side. Choose a correct side on which protrusion
fits into the saw blade hole perfectly. Next, mount the
inner flange onto the mounting shaft so that the correct
side of protrusion on the inner flange faces outward and
then place saw blade and outer flange. BE SURE TO
TIGHTEN THE HEX BOLT CLOCKWISE SECURELY.
1. Hex bolt
2. Outer flange
3. Saw blade
4. Inner flange
1. Mounting shaft
5
2. Inner flange
3. Saw blade
4. Outer flange
5. Hex bolt
4
1. Mounting shaft
5
2. Inner flange
3. Saw blade
4. Outer flange
5. Hex bolt
4
CAUTION:
Make sure that the protrusion "a" on the inner
•
flange that is positioned outside fits into the saw
blade hole "a" perfectly. Mounting the blade on the
wrong side can result in the dangerous vibration.
Hex wrench storage
013547
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
OPERATION
CAUTION:
Be sure to move the tool forward in a straight line
•
gently. Forcing or twisting the tool will result in
overheating the motor and dangerous kickback,
possibly causing severe injury.
013548
Hold the tool firmly. Set the base plate on the workpiece
to be cut without the blade making any contact. Then turn
the tool on and wait until the blade attains full speed.
Now simply move the tool forward over the workpiece
surface, keeping it flat and advancing slowly until the
sawing is completed. To get clear cuts, keep your sawing
line straight and your speed of advancing uniform.
Rip fence (Guide rule)
2
013549
8
1. Screw
1
2. Rip fence