Publicité
Les langues disponibles
Les langues disponibles
FUNCTIONAL DESCRIPTION
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function
on the tool.
Adjusting depth of cut
CAUTION:
After adjusting the depth of cut, always tighten the
•
clamping screws securely.
1
013542
Loosen the clamping screw on the depth guide and
move the base up or down. At the desired depth of cut,
secure the base by tightening the clamping screw.
For cleaner, safer cuts, set cut depth so that no more
than one blade tooth projects below workpiece. Using
proper cut depth helps to reduce potential for dangerous
KICKBACKS which can cause personal injury.
Bevel cutting
1
013543
Loosen two clamping screws on the bevel plates on the front
and back of the base. Set for the desired angle (0° - 45°) by
tilting accordingly, then tighten the clamping screws securely.
Sighting
B
1
004029
1. Clamping screw
1. Clamping screw
1
1. Base plate
A
For straight cuts, align the A position on the front of the
base with your cutting line. For 45° bevel cuts, align the
B position with it.
Switch action
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
013544
For tool with lock button
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger, push in
the lock button and then release the switch trigger.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
For tool without lock button
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Removing or installing saw blade
CAUTION:
Be sure the blade is installed with teeth pointing
•
up at the front of the tool.
Use only the Makita wrench to install or remove
•
the blade.
1
013545
To remove the blade, press the shaft lock so that the
blade cannot revolve and use the wrench to loosen the
7
1. Switch trigger
2
2. Lock button
1
1. Hex wrench
2. Shaft lock
2
Publicité
