Hilti TE 700-AVR Mode D'emploi page 14

4 Technical data
4.1 Breaker
For details of the rated voltage, frequency, current and input power,
please refer to the power tool's country-specific type identification plate.
When powered by a generator or transformer, the generator or transformer's
power output must be at least twice the rated input power shown on the rating
plate of the power tool. The operating voltage of the transformer or generator
must always be within +5% and -15% of the rated voltage of the power tool.
Single impact energy
Weight
5 Operation
5.1 Preparations at the workplace
CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Unplug the supply cord before making adjustments to the power tool or
before changing accessories.
Observe the safety instructions and warnings in this documentation and on
the product.
5.2 Fitting the side handle
CAUTION
Risk of injury! Loss of control over the breaker.
▶ Check that the side handle is fitted correctly and tightened securely.
1. Slide the side handle clamping band over the tool holder from the front
and into the recess provided.
2. Bring the side handle into the desired position.
3. Secure the side handle by turning the knob until the clamping band is
tight.
5.3 Fitting the accessory tool
WARNING
Risk of injury! The accessory tool gets hot during use and may also have
sharp edges.
▶ Wear protective gloves when changing the tool.
8 English
2
3
11.5 J
17.4 lb
(7.9 kg)
428076
*428076*