Publicité
Les langues disponibles
Les langues disponibles
SECTION 4
Completing the Installation
1. Reinstall the fan's motor bracket by sliding in place and
tightening the screws. Rotate the blower wheel by hand to
ensure it spins freely. Now plug the fan motor into the
receptacle (Figure 1).
2. Install grill by positioning over the inner housing and aligning
the center hole on the grill with the hole on the motor bracket.
Screw one side of the included grill bolt into the hole on the
motor bracket and the other side into the grill knob and turn
to tighten until the grill is tightly fit against the wall. DO NOT
OVER TIGHTEN (Figure 12).
Motor Bracket
Hole
Figure 12
3. Restore power and test your installation.
Trouble
1. Fan does not operate when the switch is on.
2. Fan is operating, but air moves slower than normal.
3. Fan is operating louder than normal.
210575005 Rev. A 10-06
Grill
Bolt
Grill Knob
Troubleshooting Guide
Probable Cause
1a. A fuse may be blown or a circuit tripped.
1b. Connector plug from motor is not plugged in.
1c. Wiring is not connected properly.
1d. Motor has stopped operating.
2. Obstruction in the outer housing.
3a. Motor is loose.
3b. Grill is loose
www.airkinglimited.com
SECTION 5
Use and Care
CAUTION:
MAKE SURE POWER IS SWITCHED OFF AT
SERVICE PANEL BEFORE SERVICING THE UNIT.
1. Cleaning the Grill: Remove grill and use a mild detergent,
such as dishwashing liquid, and dry with a soft cloth. NEVER
USE ANY ABRASIVE PADS OR SCOURING POWDERS.
Completely dry grill before reinstalling. Refer to instructions
in Section 4 Completing the Installation , to reinstall grill.
2. Cleaning the Fan Assembly: Wipe all parts with a dry cloth
or gently vacuum the fan. NEVER IMMERSE ELECTRICAL
PARTS IN WATER.
Suggested Remedy
1a. Replace fuse or reset circuit breaker.
1b. Turn off power to unit. Remove Grill and plug motor into receptacle
in housing. Restore power to unit.
1c. Turn off power to unit. Check that all wires are connected.
1d. Replace motor.
2. Check for any obstructions where the fan exhausts to the outside.
3a. Turn off power to unit. Remove grill and check that all screws are fully
tightened. Restore power to unit.
3b. Tighten grill knob.
4 of 12
Publicité
