Publicité
Les langues disponibles
Les langues disponibles
Continuous drainage
Continuous drainage can be used to avoid the water full alarm disturbance. Prepare a drain hose. Connect it to
the drain port to drain out the water. The unit can also work well.
-
If you plan to leave this unit unused for a long time, please use the drain port to drain out the water.
-
If the condensed water accumulates fast and leads to water full alarms shortly, the splash motor inside the
machine may be damaged. In this case, please contact our service department at www.emerio.eu/service
CLEANING AND MAINTENANCE
Before cleaning, be sure to disconnect the appliance from any electric supply outlet.
Do not use gasoline or other chemicals to clean the appliance.
Do not wash the appliance directly.
Air Filter
If the air filter becomes clogged with dust/dirt, the air filter should be cleaned once every two weeks.
-
Pull out the air filter (A) from the air inlet grille by the pull tab (B).
-
Clean the air filter with neutral detergent in lukewarm water (40℃) and dry it up in the shade.
-
Insert the air filter back into the air inlet grille.
Clean the Surface
First clean the surface with a neutral detergent and wet cloth, and then wipe it with a dry cloth.
TROUBLESHOOTING
Troubles
Appliance does not
start when pressing
the power button
Not cool enough
Noisy
Possible Causes
Water full indicator light blinks, and
water tray is full.
Room temperature is lower than the
setting temperature.
The doors or windows are not closed.
There are heat sources inside the room.
The hot air exhaust hose is not
connected or blocked.
Temperature setting is too high.
Air inlet is blocked.
The ground is not level or not flat
enough.
The sound comes from the flowing of
the refrigerant inside the appliance.
Solutions
Remove the rubber stopper to dump
the water out from the drainage outlet.
Reset the temperature.
Make sure all the windows and doors
are closed.
Remove the heat sources if possible.
Connect or clean the hot air exhaust
hose.
Reset the temperature.
Clean the air inlet.
Place the appliance on a flat, level
surface if possible.
It is normal.
- 7 -
Publicité
