Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION (The pictures below are for the guideline to install the appliance. The appearance of the
appliance may be different from the product you purchased.)
The unit shall be installed on a flat surface where the air outlet would not be blocked. The required
distance around the unit should be at least 30cm. (Fig.1)
The unit shall not be installed in a laundry room.
Twist part B onto the hot air exhaust hose. Attach part A to B; lock them together. Now you get the hose
connector (Air conditioner end) assembled. Twist the hose connector (Window end) onto the hot air
exhaust hose. (Fig.2)
Insert the hose connector (Air conditioner end) into the brackets on the back of the unit. (Fig.3)
Put the other end of the exhaust hose to the nearby windowsill. (Fig.4)
Fig.1
OPERATION
Always let the appliance rest for at least 2 hours after moving it from one location to another.
Before use, check up whether the exhaust hose has been mounted properly. Plug in the appliance.
1. Power button
Press the button "POWER" to turn on the appliance. The appliance will begin to work.
Press the button again, the appliance will be turned off.
2. Temperature (timer) increasing button & temperature (timer) decreasing button
Press the button "TEMP+"/"TEMP-" to set your desired room temperature from 16℃ to 31℃. The
buttons can also be used for timer adjustment from 1-24 hours during timer setting. The value will be
increased/decreased by 1 (℃/hour) for each press. Long press for rapid adjustment.
Please note: The appliance will turn off the compressor (for cooling) automatically once the room
temperature reaches the set temperature. The compressor will be turned on automatically when the room
temperature increases above the set temperature. The fan inside is always working throughout this
process. When the compressor is working, the unit will vibrate slightly. This is normal and harmless.
Fig.3
- 5 -
Fig.2
Fig.4
Publicité
