HME ion IQ Mode D'emploi

BELT-PAC AND HEADSET OPERATION:
Talk to customers
– B
Talk to crew
– ▲
Volume up or
– ▼
Volume down
–
Power on/off PWR or red button
Mode One-Touch Hands Free
With power off
Mode
Press (▲orΛ) + B + Power
Release buttons
Setup
press and release A1 or A2
button to talk to customer
Customer arrives
Single
Alert tone in headset
Touch-Release A1 or A2
Lane
Speak/Listen to customer
Operation
Touch-Release A1/A2 or B
Communication ends
In Tandem operations, Order Taker #1 uses the A1 button for
customers at order point #1 and Order Taker #2 uses the A2
Customer arrives
Alert tone in headset
1 beep = Lane 1
Dual
2 beeps = Lane 2
Touch-Release A1 for Lane 1
Lane
Touch-Release A2 for Lane 2
Touch-Release opposite button
Operation
to change lanes
Speak/Listen to customer
Touch-Release A1/A2 or B
Communication ends
With power off
Press B + A2 + Power
Release buttons
Crew Talk
Touch-Release B to
speak/listen to crew
Touch-release B again
Communication ends
COMMUNICATOR
CHANGE BATTERY:
If you hear "Battery low" or "Change battery" ─
Press battery-release button and remove battery
Place battery in battery-charger for recharging
Install fully charged battery in belt-pac or headset
For more detailed operating instructions, go to www.hme.com/userManuals.cfm
For HELP call HME Technical Support at 1-800-848-4468 or Fax (858) 552-0172
All manuals and user guides at all-guides.com
– A1 A2
or
Λ
or V
In this mode,
button for customers a order point #2
STATUS:
®
With power off ● Press A2 + (▼or V) + Power ● Release buttons
Drive-Thru Communication System
Push To Talk
With power off
Press (▼orV) + B + Power
Release buttons
In this mode,
press and hold A1 or A2 button
to talk to customer
Customer arrives
Alert tone in headset
Press & hold A1 or A2
Speak to customer
Release to listen
t
Customer arrives
Alert tone in headset
1 beep = Lane 1
2 beeps = Lane 2
Press & hold A1 for Lane 1
Press & hold A2 for Lane 2
Speak to customer
Release A1/A2 to listen
With power off
Press B + A2 + Power
Release buttons
Press & hold B to speak to crew
Release to listen
Battery-release
Battery
Power on/off
(red button)
Auto Hands Free
With power off
Press (▲orΛ) + (A1/A2) + Power
(A1 for Lane 1 – A2 for Lane 2)
Release buttons
In this mode,
talk to customer
without pressing buttons
Customer arrives
Alert tone in headset
Speak/Listen to customer
Touch-Release A1/A2 or B
Communication ends
In Tandem operations,
only Order Taker #1 can operate
in the Auto Hands Free mode
Customer arrives
Alert tone in headset
1 beep = Lane 1
2 beeps = Lane 2
Speak/Listen to customer
Touch-Release A1/A2 or B
Communication ends
Battery-release
button
button (blue)
Battery
HME# 400G665F
Rev A 4/8/11