Publicité
Les langues disponibles
Les langues disponibles
•
Objects that hit against the cutting equipment
can be ejected and cause damage to persons
and objects.
•
Do not use the product in bad weather,
including fog, rain, moist or wet locations,
strong winds, intense cold and risk of
lightning. Doing work in bad weather can
cause fatigue and dangerous conditions, such
as slippery surfaces.
•
Examine your work area to make sure
that your control of the product cannot be
prevented.
•
Be careful of roots, stones, twigs, pits and
ditches. High grass can conceal obstacles.
•
Do not operate the product on slopes that are
more than 15 degrees.
•
Operate the product along slopes. Do not
move up and down the slope.
•
Be careful when you go near hidden corners
and objects that can prevent your view.
Work safety
WARNING:
instructions that follow before you use
the product.
•
Use this product to cut grass lawns only. It is
not permitted to use it for other tasks.
•
Use personal protective equipment. See
Personal protective equipment on page 8 .
•
Do not operate the product in rain or
wet conditions. The risk of electrical shock
increases if water enters the product.
•
Do not operate the product unless the blade
and all covers are attached correctly. An
incorrectly attached blade can come loose
and cause personal injury.
•
Make sure that the blade does not hit objects
such as stones and roots. This can do
damage to the blade and bend the motor
shaft. A bent axle causes heavy vibration and
a very high risk that the blade becomes loose.
•
If the blade hits an object or if vibrations
occur, stop the product immediately. Stop the
motor, turn the safety key to 0 and remove the
battery. Examine the product for damages.
Repair damages or let an authorised service
agent do the repair.
•
Never attach the motor brake handle
permanently to the handle when the motor is
started.
8
Read the warning
•
Put the product on a stable, flat surface and
start it. Make sure that the blade does not hit
the ground or other objects.
•
Always stay behind the product when you
operate it.
•
Let all the wheels stay on the ground and
keep 2 hands on the handle when you
operate the product. Keep your hands and
feet away from the rotating blades.
•
Do not tilt the product when the motor is
started.
•
Be careful when you pull the product
rearward.
•
Never lift up the product when the motor is
started. If you must lift the product, first stop
the motor and remove the battery.
•
Do not walk rearward when you operate the
product.
•
Stop the motor when you move across areas
without grass, for example paths made of
gravel, stone and asphalt.
•
Do not run with the product when the motor
is started. Always walk when you operate the
product.
•
Stop the motor before you change the cutting
height. Never make adjustments with the
motor started.
•
Never let the product stay out of view with the
motor started. Stop the motor and make sure
that the cutting equipment does not rotate.
Safety instructions for operation
Personal protective equipment
WARNING:
instructions that follow before you use
the product.
•
Personal protective equipment cannot fully
prevent injury but it decreases the degree
of injury if an accident does occur. Let your
dealer help you select the right equipment.
•
Use hearing protection if the noise level is
higher than 85 dB.
•
Use heavy-duty slip-resistant boots or shoes.
Do not use open shoes or go with bare feet.
•
Use heavy, long pants.
•
Use protective gloves when necessary, for
example when you attach, examine or clean
the cutting equipment.
Read the warning
1840 - 005 - 11.07.2023
Publicité
