Specifications - Sony TC-WE825S Mode D'emploi

Specifications

System
Recording system
4-track 2-channel stereo
Fast-winding time (approx.)
90 sec. (with Sony C-60 cassette)
High-speed fast-winding time (approx.) (TC-WE825S and TC-WE725
only)
45 sec. (with Sony C-60 cassette)
Bias
AC bias
Signal-to-noise ratio (at peak level and weighted with Dolby NR off)
Type I tape, Sony Type I (NORMAL): 55 dB
Type II tape, Sony Type II (HIGH): 57 dB
Type IV tape, Sony Type IV (METAL): 58 dB
S/N ratio improvement (approximate values)
With Dolby B NR on: 5 dB at 1 kHz, 10 dB at 5 kHz
With Dolby C NR on: 15 dB at 500 Hz, 20 dB at 1 kHz
With Dolby S NR on (TC-WE825S only): 10 dB at 100
Hz, 24 dB at 1 kHz
Harmonic distortion
0.4% (with Type I tape, Sony Type I (NORMAL):
160 nWb/m 315 Hz, 3rd H.D.)
1.8% (with Type IV tape, Sony Type IV (METAL):
250 nWb/m 315 Hz, 3rd H.D.)
Frequency response (Dolby NR off)
Tape type
Type I tape, Sony Type I
(NORMAL)
Type II tape, Sony Type II (HIGH)
Type IV tape, Sony Type IV
(METAL)
Wow and flutter
±0.13% W. Peak (IEC)
0.07% W. RMS (NAB)
±0.18% W. Peak (DIN)
Variable pitch range (approx.)
–30 to +30%
30 – 16,000 Hz (±3 dB, IEC),
20 – 17,000 Hz (±6 dB)
30 – 17,000 Hz (±3 dB, IEC),
20 – 18,000 Hz (±6 dB)
30 – 19,000 Hz (±3 dB, IEC),
20 – 20,000 Hz (±6 dB),
30 – 13,000 Hz (±3 dB, –4 dB
recording)
Additional Information
Inputs
Line inputs (phono jacks)
Sensitivity : 0.16 V
Input impedance : 47 kilohms
Outputs
Line outputs (phono jacks)
Rated output level : 0.5 V at a load impedance of
47 kilohms
Load impedance : Over 10 kilohms
Headphones (stereo phone jack)
Output level : 0.25 mW at a load impedance of
32 ohms
General
Power requirements
Where purchased Power requirements
220 – 230 V AC, 50/60 Hz
Continental Europe
Other countries 120/220/230 – 240 V AC,
50/60 Hz
Power consumption
30 W
Dimensions (approx) (w/h/d)
430 × 120 × 290 mm (w/h/d)
including projecting parts and controls
Mass (approx.)
4.3 kg
Supplied accessories
Audio connecting cords (2 phono plugs - 2 phono
plugs) (2)
Optional accessory
Remote commander RM-J910
For more information on the availability of the remote
commander, contact your nearest Sony dealer.
Design and specifications are subject to change without
notice.
EN
21