Kohler K-8548 Guide D'installation page 5

3. Install the Diverter
For Finished Deck Installations
At the diverter install location, drill a 1-1/2" (3.8 cm) hole.
For All Installations
NOTE: You may need assistance to align and secure the diverter.
Thread the mounting nut all the way down onto the diverter
body.
Slide the friction washer followed by the rubber washer over the
diverter body and down to the mounting nut.
Insert the diverter body through the deck/rim/wall.
Slide the washer onto the diverter body.
Thread the escutcheon onto the diverter body until the top of the
escutcheon is flush with the top of the diverter body. This will
allow ample clearance for proper handle function.
Align the inlets and outlets.
Hand tighten the mounting nut.
Kohler Co.
All manuals and user guides at all-guides.com
Deck/Rim
Brass
Mounting
Nut
Escutcheon
Washer
Rubber
Washer
Friction
Washer
5 1000588-2-C