Table Des Matières; Operating Controls - Sharp CS-1194H Mode D'emploi

• OPERATING CONTROLS ........................................................................................ 3

• INK RIBBON REPLACEMENT ................................................................................. 7
• PAPER ROLL REPLACEMENT ................................................................................ 8
• ERRORS ................................................................................................................... 9
• SPECIFICATIONS .................................................................................................... 9
• CALCULATION EXAMPLES ................................................................................... 26
• TAX RATE CALCULATIONS ................................................................................... 39
• DISCOUNT RATE CALCULATION ......................................................................... 41
POWER SWITCH; PRINT / ITEM COUNT MODE SELECTOR:
"OFF": Power OFF.
"•":
"P":
"P•IC": Power ON. Set to the print and item count mode.
Notes: • Each time
DECIMAL SELECTOR:
Presets the number of decimal places in the answer.
In the "F" position, the answer is displayed in the floating decimal
system.
CONTENTS
OPERATING CONTROLS
Power ON. Set to the non-print mode.
("• • • ... • • • -P" will be printed.)
Power ON. Set to the print mode.
("• • • ... • • • +P" will be printed.)
The counter will count the number of times that
pressed in addition.
is used in subtraction, 1 will be subtracted from
the count.
• The count is printed when the calculated result is obtained.
• Pressing of
,
• The counter has a maximum capacity of 3 digits (up to ±999).
If the count exceeds the maximum, the counter will recount
from zero.
or clears the counter.
- 3 -
Page
has been