Hobby ClimaControl Mode D'emploi page 30

6. Factory settings / Reset
Clock setting:
Humidity:
Temperature:
Audible alarm temperature:
Audible alarm humidity:
Visual alarm temperature:
Visual alarm humidity:
Safety function:
Temperature mode:
Timer mode:
Should your ClimaControl not function correctly, please perform a reset:
1. Unplug from mains
2. Plug the mains plug back in while keeping the
3. Release the button
Attention: All programmed settings, except those for the clock, are lost. The ClimaControl will regulate temperature
or humidity with factory's presettings (humidity: 70 % RH / temperature: HEATing mode, 25° C).
7. Causes of error
In the event of a claims issue, please perform a reset to factory settings in the fi rst instance. If this does not eliminate
the fault or error, please identify the fault using the table below:
Error
Display indication E1
Display indication E2
Display indication E3
Display indication E4
Display indication E5
14
All manuals and user guides at all-guides.com
12:00:00
70 % relative humidity
25° C
deactivated (BEEP OFF)
deactivated (BEEP OFF)
deactivated (00 means no alarm)
deactivated (00 means no alarm)
deactivated (00 means no safety function)
HEATing
Aut (means 'automatic')
Possible cause
Temperature sensor cable break
Humidity sensor cable break
Error in time settings for humidity con-
trol or temperature control on slot 1
Safety cut-out function active (failure
to achieve programmed humidity is
detected as an error)
Error in time settings for temperature
control or timer control on slot 2
button pressed
Solution
Send device in for repair
Send device in for repair
Ensure that the programmed times do not
overlap
Check position of humidity sensor / increase
the period after which devices are switched
off / lower desired value for relative humidity /
connect a more powerful humidifi er
Ensure that the programmed times do not
overlap