Kohler K-1647 Guide Du Propriétaire page 5

Limited Three-Year Warranty (cont.)
and/or seller disclaim all liability for special, incidental or consequential damages.
Some states/provinces do not allow limitations on how long an implied warranty lasts, or the exclusion or
limitations of special, incidental or consequential damages, so these limitations and exclusions may not apply
to you. This warranty gives you specific legal rights. You may also have other rights, which vary, from
state/providence to state/providence.
This is Kohler Co.'s exclusive written warranty.
Troubleshooting Procedures
This troubleshooting guide is for general aid only. For service and installation issues and concerns, call
1-800-585–STEAM (7832).
Symptoms
1. "Err 1" appears on the
control pad.
2. "Err 2" appears on the
control pad.
3. "Err 3" appears on the
control pad.
4. "Err 4" appears on the
control pad.
5. "Err 5" appears on the
control pad.
6. "Err 6" appears on the
control pad.
7. "Err 7" appears on the
control pad.
8. "Err 8" appears on the
control pad.
9. Unit shuts off.
10. No steam is being
generated.
11. There is a continuous
flow of water from the
steam head. (Water flow
during automatic purge
cycle is normal.)
Kohler Co.
All manuals and user guides at all-guides.com
Probable Causes
A. The power button is stuck.
A. "Up button" is stuck.
A. "Down button" is stuck.
A. "Time" button is stuck.
A. Maximum heat has been
exceeded. The generator is not
getting enough water.
B. Water feed assembly is blocked.
A. Indicates float switch tripped
for 10 seconds.
A. "Temperature" button is stuck.
A. "Clock" button is stuck.
A. Unit has been in operation for
more than 20 minutes.
A. Piping not properly attached.
B. Steam head blocked.
A. Water supply incorrectly
attached to steam generator.
B. Water feed assembly is stuck.
5
Recommended Action
A. Reset the power at the breaker.
A. Reset the power at the breaker.
A. Reset the power at the breaker.
A. Reset the power at the breaker.
A. Check the water supply for proper
flow.
B. Remove and inspect the water feed
assembly in the generator.
A. Shut off the system and allow it to
cool.
A. Reset the power at the breaker.
A. Reset the power at the breaker.
A. Turn unit back on.
A. Reattach the pipes properly.
B. Remove the steam head (after
cooling) and check that the plunger
slides freely in the cap.
A. Connect the water supply to the
proper inlet.
B. Remove and inspect the water feed
assembly in the generator.
1045789-5-F