Skil 8100 Notice Originale page 9

Do not connect the blue (= neutral) or brown (= live) wire
in the cord of this tool to the earth terminal of the plug
this tool, it must be disposed of safely and not left
unattended
USE
Changing cleaning discs 7
! disconnect the plug
-
pushing spindle-lock button C
- remove old cleaning disc D and place new one onto
spindle E
-
pushing spindle-lock button C
Mounting/removing backing pad/sanding sheet/wool
bonnet 8
! disconnect the plug
- remove cleaning disc D 2
-
pushing spindle-lock button C
- for sanding simply press sanding sheet H onto
- for polishing simply press wool bonnet J onto VELCRO
- for removing backing pad/sanding sheet/wool bonnet
handle vice-versa
! replace damaged backing pads immediately
Auxiliary handle 9
- press two buttons K simultaneously to unlock handle L
- handle L will lock into place when fully vertical or
horizontal
Dust suction q
- connect vacuum cleaner to extension M
! do not use vacuum cleaner when sanding metal
- switch on tool w a
! be aware of the sudden impact when the tool is
switched on
! before the accessory reaches the workpiece, the
tool should run at full speed
-
!
from the workpiece
! the accessory continues to rotate for a short time
Before using the tool
-
tightened
- check if accessory runs freely by turning it by hand
- test-run tool for at least 60 seconds at highest no-load
speed in a safe position
- stop immediately in case of considerable vibration or
other defects and check tool to determine the cause
Operating the tool e
!
- move the tool back and forth with moderate pressure
- always tilt the tool somewhat when working
Holding and guiding the tool r
!
coloured grip area(s)
2
w
w b
-
have full control of the tool at all times
- pay attention to the direction of rotation; always hold
away from the body
- for a better grip use hand strap P as illustrated
- provide for a secure stance
- keep ventilation slots Q 2 uncovered
APPLICATION ADVICE
For sanding with high removal performance use the tool
in combination with cleaning disc D 2
sheet H 2
J 2
For more tips see www.skil.com
MAINTENANCE / SERVICE
2 and
This tool is not intended for professional use
Always keep tool and cord clean (especially ventilation
slots Q 2 )
! do not attempt to clean ventilation slots by
inserting pointed objects through openings
! disconnect the plug before cleaning
When too much paint is embedded into cleaning disc D
2 , clean the disc as follows:
- run the disc momentarily on a concrete sidewalk or a
large concrete block for knocking the paint loose from
the disc
- ensure the cleaning surface is stable
! never immerse the cleaning disc into a solvent
such as turpentine
If the tool should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for SKIL
power tools
- send the tool undismantled together with proof of
purchase to your dealer or the nearest SKIL service
station (addresses as well as the service diagram of
the tool are listed on www.skil.com)
ENVIRONMENT
Do not dispose of electric tools, accessories and
packaging together with household waste material
(only for EU countries)
- in observance of European Directive 2012/19/EC
on waste of electric and electronic equipment and
its implementation in accordance with national law,
electric tools that have reached the end of their life
must be collected separately and returned to an
environmentally compatible recycling facility
- symbol 6 will remind you of this when the need for
disposing occurs
DECLARATION OF CONFORMITY
We declare under our sole responsibility that the product
described under "Technical data" is in conformity with
the following standards or standardization documents:
EN 60745, EN 61000, EN 55014, in accordance with the
provisions of the directives 2004/108/EC, 2006/42/EC,
2011/65/EU
9
2 with sanding
2 with wool bonnet