Black & Decker EGBHP146 Mode D'emploi page 7

Additional safety instructions for
batteries and chargers
Batteries
• Never attempt to open for any reason.
• Do not expose the battery to water.
• Do not store in locations where the
temperature may exceed 40 °C.
• Charge only at ambient temperatures
between 10 °C and 40 °C.
• Charge only using the charger provided
with the tool.
• When disposing of batteries, follow the
instructions given in the section
"Protecting the environment".
Do not attempt to charge damaged
batteries.
Chargers
• Use your BLACK+DECKER charger only
to charge the battery in the tool with
which it was supplied. Other batteries
could burst, causing personal injury and
damage.
• Never attempt to charge
non-rechargeable batteries.
• Have defective cords replaced
immediately.
• Do not expose the charger to water.
• Do not open the charger.
• Do not probe the charger.
The charger is intended for indoor
use only.
Read the instruction manual before
use.
Electrical safety
Your charger is double insulated;
therefore no earth wire is required.
Always check that the mains voltage
corresponds to the voltage on the
rating plate. Never attempt to replace
the charger unit with a regular mains
plug.
All manuals and user guides at all-guides.com
(Original instructions)
• If the supply cord is damaged, it must be
Features
This tool includes some or all of the
following features.
1. Variable speed switch
2. Forward/reverse slider
3. Mode selector / torque adjustment collar
4. Chuck
5. Speed selector
6. Bit holder
7. Battery
Fig. A
8. Charger
9. Charge indicator
Assembly
Warning! Before assembly, remove the
battery from the tool.
Fitting and removing the battery (fig. B)
• To fit the battery (7), line it up with the
• To remove the battery, push the release
Fitting and removing a drill bit or
screwdriver bit
This tool is fitted with a keyless chuck to
allow for an easy exchange of bits.
• Lock the tool by setting the
• Open the chuck by turning it (4) with one
• Insert the bit shaft into the chuck.
replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
receptacle on the tool. Slide the battery
into the receptacle and push until the
battery snaps into place.
button (10) while at the same time pulling
the battery out of the receptacle.
forward/reverse slider (2) to the centre
position.
hand while holding the tool with the
other.
ENGLISH
7