Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS
CAUTION:
MAKE SURE POWER IS SWITCHED OFF AT SERVICE PANEL BEFORE
STARTING INSTALLATION.
WARNING:
TO REDUCE THE RISK OF FIRE, DO NOT STORE OR USE GASOLINE
OR OTHER FLAMMABLE VAPORS AND LIQUIDS IN THE VICINITY OF THE HEATER.
SECTION 1
Preparing the Exhaust Fan
1.
Unpack fan from the carton and confirm that all pieces are present. In addition to the
exhaust fan you should have:
1 - Grill with Light Lens
4 - Mounting Rails
2 - 2 Function Switches
1 - Quad Wall Plate
1 - Instruction/Safety Sheet
2.
Remove the two machine screws holding the light reflector in place. Keep the reflector
and screws in the carton until needed so they do not get damaged or lost (Figure 1).
Figure 1
3.
Remove the wire compartment cover by loosening the two screws holding the cover in
place (Figure 2).
Figure 2
WARNING:
DO NOT INSTALL OVER A TUB OR MOUNT IN A SHOWER STALL
ENCLOSURE.
4.
Choose the location for your unit. To ensure the best
air and sound performance, it is recommended that
the length of ducting and the number of elbows be
kept to a minimum, and that insulated hard ducting be
used. Larger duct sizes will reduce noise and airflow
restrictions. This fan will require at least 7" of clearance
in the ceiling, and will mount through drywall up to 3/4"
thick. The fan can be mounted directly to the joist using
the mounting tabs on the side of the housing or between
16" on center joists using the 4 provided mounting rails.
5.
Remove the electrical knockouts using a straight-blade
screw driver (Figure 3).
SECTION 2
New Construction
1.
Mounting Rail Installation: Install the rails on the housing and position the housing next
to the joist. Line up housing so it will be flush with the finished ceiling. Secure the ends
of the rails with screws or nails (not included) to the joists and slide housing into final
position (Figure 4).
965 Rev. D 5-14
All manuals and user guides at all-guides.com
Screws
Screws
Compartment
Figure 3
Housing
Figure 4
1a. Mounting Tab Installation: Line up housing so that it will be flush with the finished
ceiling. Position the fan so that the tabs rest flat against the joist and secure with screws
or nails (not provided) to ensure proper installation (Figure 5).
Figure 5
SECTION 3
Existing Construction
1.
Mounting Rail Installation: Set housing in position between the joist and trace an outline
onto the ceiling material (Figure 6). Set housing aside and cut opening, being careful not
to cut or damage any electrical or other hidden utilities. Install the rails on the housing and
Wire
position the housing in the previously cut hole so that it is flush with the finished ceiling.
Secure the ends of the rails to the joists with screws or nails (not provided) to ensure proper
installation (Figure 4).
Cover
Figure 6
1a. Mounting Tab Installation: Position housing against the joist and trace an outline of the
housing onto the ceiling material (Figure 7). Set housing aside and cut opening, being
careful not to cut or damage any electrical or other hidden utilities. Place housing next to
the joist and insure that it is flush with the finished ceiling. Secure with screws or nails (not
provided) to the joists (Figure 5).
Figure 7
www.airkinglimited.com
Joist
Mounting Rails
2 of 12
Publicité
