Publicité
Les langues disponibles
Les langues disponibles
2.2.2 Electrical installation
There are two versions of NTP clocks: PoE or 230V
Refer to the product label to determine which version you have.
The lighting (if this option has been selected) is always powered via a mains power supply.
However, the power supply of the electronic card may vary according to your model:
NTP PoE model: the power supply of the card is provided via the Ethernet cable,
NTP 230V
model: the power supply of the card is provided via a second power supply (15V)
connected to the mains.
2.2.2.1 NTP 230V model
Run a mains cable through the
1
bracket arm, then connect this
cable to the terminal block in the
L-N-
terminals dedicated to
the electronic card (icon
If the clock has the lighting option,
the 2 mains cables must come
from the same building.
2
Attach this mains cable to the
central bracket with a cable
retainer.
3
Run the Ethernet cable through
the bracket arm (crimp and test
the cable if necessary).
Connect
this
4
electronic card via the Ethernet
port.
Connect the backup battery cable
5
(if available) to the electronic
card.
46
).
cable
to
the
.
Ethernet cable
Ø 1,5 mm
2
230 V
EN
NTP
Publicité
