Publicité
Les langues disponibles
Les langues disponibles
2. INSTALLATION
2.1 Single-sided clock
2.1.1 Mechanical installation
2.1.1.1 Wall mounting
The clock must be previously opened before being mounted onto the wall.
Follow the steps below to proceed with the mechanical installation of the clock.
Unscrew and remove the air inlet screw
1
beneath the clock to let air in.
(6 mm Allen key, tightening torque: 15 Nm)
Partially unscrew the four cover screws
2
(two on each side) located on the clock.
(3 mm Allen key, tightening torque: 1.2 Nm)
Carefully slide open and partially separate
3
the front face to access the clock's internal
cabling,
Disconnect the flat cable connected to the
4
movement of the front face of the clock.
Remove the front face completely. You are
5
now able to access the inside of the clock
and proceed with the wall mounting.
Place the front face on a straight, clean and
6
uncluttered work surface.
Remove the cardboard wedge between the
7
movement and the dial.
Where the clock is to be installed, drill three
8
holes in the wall according to the following
layout and dimensions pertaining to your
model.
In the case of a standard mounting on a
9
concrete wall, insert the wall plugs into the
drilled holes.
Screw the stud bolts into the wall plugs
10
(3 stud bolts are provided with the clock in a
separate package).
Anticipate the adjustment of the nuts and
11
washers in order to leave enough space
(at least 25 mm) between the wall and the
back of the clock to run the cables and cable
glands.
Run all the cables through the cable glands
12
before installing the clock on the stud bolts.
Fix the clock on the stud bolts using the
13
washers and nuts.
Proceed with the clock's internal cabling.
14
Refer to the following chapters of this manual
according to your model.
X4
M8
M8
M8
E
F
25mm
(mm)
A
B
C
A
D
E
F
B
EN
P750
P760
P780
540
640
840
125
125
125
325
410
570
135
170
230
135
170
250
270
340
500
37
Publicité
