Publicité
Les langues disponibles
Les langues disponibles
It is recommended to apply a silicone seal
between the plate and the wall to ensure
correct sealing.
Place the clock on the bracket starting with
11
the first fixing point at the top with a threaded
rod and 2 nuts.
Continue fixing the clock to the bracket by
12
inserting the 2 fixing screws at the bottom of
the bracket.
Finish fixing the clock on the bracket with
13
washers and nuts by tightening the 3 fixing
points.
Run all the cables through the clock's cable
14
glands.
If a back cover is available for the bracket,
15
fix the back cover to the bracket using the
self-drilling screws supplied.
Proceed with the clock's internal cabling.
16
Refer to the following chapters of this manual
according to your model.
Once the clock has been wired, clean the
17
seal and apply silicone oil on it.
Realign the front face of the clock and
18
reconnect the flat cable from the electronic
card to the movement located on the front
face.
Limit the length of the cable by running it
19
through the cable clip in order to avoid
shading in the case of the lighting option
(contact of the cable with the dial once the
clock is closed).
Close the clock by placing the front face back
20
into its original position.
21
Tighten the four cover screws (1.2 Nm).
Replace and tighten the air inlet screw
22
(15 Nm) located under the clock.
(mm)
P750
P760
P780
A1
153
150
160
B1
423
470
580
C1
172
172
173
D1
540
640
840
E1
70
70
70
F1
100
100
100
G1
150
150
150
H1
74
74
74
I1
34
34
34
M8x65
M8x25
x4 P750
P750
x6 P760
P760
x8 P780
X4
A1
B1
EN
F1
D1
H1
I1
C1
39
Publicité
